If you look back on that last post where you saw a very aerodynamic nosecone, you might notice that it is very pointy. It has just occurred to me that Mr. Barnhart might not appreciate a hard plastic pointy thing falling out of the sky while the pointy thing points downwards at him, sooo I took this opportunity to reduce the print time slightly by blunting the nose and putting a hole down the central shaft of the cone. I will make the nose pointy with something else that won't hurt as much as plastic, like paper or foam. That hole down the center also gives me the freedom of adding as much or as little weight to the nosecone as I want. Also, I have added a new site banner that has some rocket equations on it. I think it looks good.
0 Comments
Leave a Reply. |
Jacob mitchellI like to play computer games, program, and try my hand at 3D printing. Archives
February 2017
Categories |